treasuregaq.blogg.se - What is a cisco udi

There is no network command for the network 192.168.1.0/24 on R1.ħ.

The automatic summarization is enabled on R1 and R2.

The AS number does not match on R1 and R2.*.

The IPv4 address of Fa0/0 interface of R1 has a wrong IP address.

Why did R1 and R2 not establish an adjacency? In RSTP, BPDU frames are sent every _ seconds by default.Ħ.

S3 will set the priority value for VLAN 30 to 8192.*.

S1 will set the priority value for VLAN 10 to 0.

S2 will set the priority value for VLAN 10 to 24576.

S1 will set the priority value for VLAN 20 to 24596.

What will be a result of entering these commands? A network administrator is configuring PVST+ for the three switches. Which switch will be the root bridge after the election process is complete?Ĥ.

It specifies the EIGRP routing process on a router.*ģ.

It is associated with the global Autonomous System number that is assigned by IANA.

It defines the reliability of the EIGRP routing protocol.

It identifies the priority of the networks to be included in update packets.

Which statement describes the Autonomous System number that is used in EIGRP?

Verify that the switch has a higher configuration revision number.Ģ.

Configure the VTP mode of the switch to transparent.*.

Configure the switch with the same VTP domain name as other switches in the network.*.

Which two steps should the administrator perform to achieve this? (Choose two.)Reset the VTP counters.

The network administrator wants to configure a switch to pass VLAN update information to other switches in the domain but not update its own local VLAN database. Read Chapter wise CCNA 3 Exam Answers (v5.1 + v6.0)ġ. CCNA 3 Practice Final Exam Answers 2019-2020 (v5.0.3 + v6.0) CCNA 3 Practice Final Exam Answers 2019-20